I read an article recently which told of using wider pads (.016) with
smaller spaces (.004) on 20 mil pitch parts. I have misplaced the magazine
and can't remember it's name. If any of you read the same article, would
you please tell me the publication name and what issue it was in?
Thanks.
Charlie B.
[log in to unmask]
################################################################
TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe: SUBSCRIBE TechNet <your full name>
To unsubscribe: SIGNOFF TechNet
################################################################
Please visit IPC's web site (http://www.ipc.org) "On-Line Services" section for additional information.
For technical support contact Hugo Scaramuzza at [log in to unmask] or 847-509-9700 ext.312
################################################################