Paul Anderson wrote:
>
> snip <
> Have any other powerpcb 2.1 users experienced similar problems with
> import/export?

        We've not seen this exact situation, to my knowledge,
        but we're on NT and our Pads folks aren't in today
        (sounds like you're having a tough Saturday).
>
> Since all I would really need to save from the original PCB is the
> component placement info
> and the card outline, is there a way to just export that data separate
> from all the rest and import
> the current netlist info?
>
        You can selectively export ascii, I'd suggest taking only
        the decals and the placement, then read in your new netlist
        (not through ECO).

        It's been long enough since I've used the product that I
        can't just rattle off the commands to do this, but I recall
        it's pretty intuitive.

        BTW, I'd suggest you'll have better luck with these kinds
        of issues on the [log in to unmask] mail group, if
        you didn't try there already.

        Good luck,
--

      Jeff Seeger                         Applied CAD Knowledge Inc
      Chief Technical Officer                  Tyngsboro, MA  01879
      jseeger "at" appliedcad "dot" com                978 649 9800

################################################################
TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe:   SUBSCRIBE TechNet <your full name>
To unsubscribe:   SIGNOFF TechNet 
################################################################
Please visit IPC's web site (http://www.ipc.org) "On-Line Services" section for additional information.
For technical support contact Hugo Scaramuzza at [log in to unmask] or 847-509-9700 ext.312
################################################################