Designers,
We have a midplane attached to a metal chassis. There are some vias that
appear to be very close to the chassis and I was wondering what the
guideline is for spacing from any via/etch/signal to chassis might be.
While I am busy looking through the IPC design rules, I thought I'd throw
it out on Technet to see what other opinions and guidelines might be shared.
Thanks in advance.....DT
################################################################
TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe: SUBSCRIBE TechNet <your full name>
To unsubscribe: SIGNOFF TechNet
################################################################
Please visit IPC's web site (http://www.ipc.org) "On-Line Services" section for additional information.
For technical support contact Hugo Scaramuzza at [log in to unmask] or 847-509-9700 ext.312
################################################################