Mime-Version: |
1.0 |
Sender: |
|
Subject: |
|
From: |
|
Date: |
Thu, 27 Aug 1998 12:44:32 -0500 |
Content-type: |
text/plain; charset=us-ascii |
Reply-To: |
|
Parts/Attachments: |
|
|
General Question to anyone. If you were to go out and build the ideal
stencil for
pasting boards, what would be the best way to build a stencil? I have some
boards
that have 19.7 mil pitch parts and the pad width is 10 mil. The length of
the pad is
59 mil. I can't change the pad design. Ideas I am looking for are opening
sizes of the
apperatures, what type of etching, what type of plating, and thickness of
the stencil.
Other ideas are appreciated. Thank you in advance.
Rob
################################################################
TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe: SUBSCRIBE TechNet <your full name>
To unsubscribe: SIGNOFF TechNet
################################################################
Please visit IPC's web site (http://www.ipc.org) "On-Line Services" section for additional information.
For technical support contact Hugo Scaramuzza at [log in to unmask] or 847-509-9700 ext.312
################################################################
|
|
|