Subject: | |
From: | |
Reply To: | |
Date: | Mon, 6 Jul 1998 17:55:48 -0400 |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
Hey Steve, how ya doin'?
We just ordered a set of plyimide stencils and the very initial
results are excellent. We spec'd them the same as our stainless, in
regards to thickness etc. I think they stock 5-8 mil but can go as thin
as 2 mil. You better check those figures, though. The only thing that
changed was that the paste-release was significantly improved, and
set-up time was cut in half because the operator can see through the
stencil. We are using a metal blade, and we had them laser cut the
whole thing. They have their ballpark pricing on their homepage, but it
was about $375 for a 2000 aperture stencil ($300 for first order). We
do not use ultra-sonic cleaning, but their hompepage discusses that,
too. Hope this helps, Steve!
Ryan Jennens
Phoenix Engineering
################################################################
TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe: SUBSCRIBE TechNet <your full name>
To unsubscribe: SIGNOFF TechNet
################################################################
Please visit IPC's web site (http://www.ipc.org) "On-Line Services" section for additional information.
For technical support contact Hugo Scaramuzza at [log in to unmask] or 847-509-9700 ext.312
################################################################
|
|
|