Hi everyone
Please pardon me for my ignorance regarding this
matter but I will ask this question anyway:
- is it possible that the plating thickness on the board
surface is less than that of the T/H?
- what might be the cause of this type of phenomenon?
Any comments or information anyone could provide
is highly appreciated.
thanks
Sarah
################################################################
TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe: SUBSCRIBE TechNet <your full name>
To unsubscribe: SIGNOFF TechNet
################################################################
Please visit IPC's web site (http://www.ipc.org) "On-Line Services" section for additional information.
For technical support contact Hugo Scaramuzza at [log in to unmask] or 847-509-9700 ext.312
################################################################