Jared-
I am not sure that heat alone is enough to burn off oxides. Also,
the stress to the components could be significant. Would it be possible
to use a more active flux to chemically remove the oxides before the
wave until you determine if the leads are above a standard solderability
limit?
Ryan Jennens
Phoenix Engineering
################################################################
TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe: SUBSCRIBE TechNet <your full name>
To unsubscribe: SIGNOFF TechNet
################################################################
Please visit IPC's web site (http://www.ipc.org) "On-Line Services" section for additional information.
For technical support contact Hugo Scaramuzza at [log in to unmask] or 847-509-9700 ext.312
################################################################