Hello everyone,

Who out there knows anything about hot bar soldering?? We are
considering using an LCD with a TAB driver that requires hot bar
soldering to the PCB. The problem is I have no experience with this
process - can anyone please explain to me what is involved, and what
the pros and cons of using such a process are?

Thanks very much.

Regards,


Bruce Robertson
Production Engineering
Mobile Radio Division
Tait Electronics Ltd.
------------------------------------------------------
558 Wairakei Road, PO Box 1645
Christchurch, New Zealand.
Direct Phone: (64)(3) 3580376 Fax: (64)(3) 358 3603
Email: [log in to unmask]  Internet: http://www.tait.co.nz
------------------------------------------------------

################################################################
TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe:   SUBSCRIBE TechNet <your full name>
To unsubscribe:   SIGNOFF TechNet 
################################################################
Please visit IPC's web site (http://www.ipc.org) "On-Line Services" section for additional information.
For technical support contact Hugo Scaramuzza at [log in to unmask] or 847-509-9700 ext.312
################################################################