Subject: | |
From: | |
Reply To: | TechNet E-Mail Forum. |
Date: | Fri, 17 Jul 1998 13:07:50 EDT |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
With the right no clean applied below a critical level, I haven't had a
problem with other acrylics.
In testing new no cleans, I found some are incompatable, but most are fine,
as long as the spray fluxer is below a certain level. The critical level is
more flux than required for good soldering.
ARIC PARR
Sr. Manufacturing Engineer
Eaton Corp
1400 S. Livernois
P. O. Box 5020
Rochester Hills, Mi 48308-5020
[log in to unmask]
248 608 7780
Fax: 248 656 2242
-------------
Original Text
From: C=US/A=INTERNET/DDA=ID/TechNet(a)IPC.ORG, on 7/17/98 12:20 PM:
To: Aric Parr@01635@Lectron_RH,
EatonWHQ@CorpMail@WHQCleveOH[C=US/A=INTERNET/DDA=ID/TechNet(a)IPC.ORG]
Has anyone had experience with conformal coating over a "no-clean"
flux residue? Right now we are using a Humiseal - 1B73 Acrylic,
and using a water soluble flux. We are in the process of going
outside with this assembly and most of the contract houses that we
have talked with use no clean. thanks
Mark
ADC Telecom.
################################################################
TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following
text in the body:
To subscribe: SUBSCRIBE TechNet <your full name>
To unsubscribe: SIGNOFF TechNet
################################################################
Please visit IPC's web site (http://www.ipc.org) "On-Line Services" section
for additional information.
For technical support contact Hugo Scaramuzza at [log in to unmask] or
847-509-9700 ext.312
################################################################
################################################################
TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe: SUBSCRIBE TechNet <your full name>
To unsubscribe: SIGNOFF TechNet
################################################################
Please visit IPC's web site (http://www.ipc.org) "On-Line Services" section for additional information.
For technical support contact Hugo Scaramuzza at [log in to unmask] or 847-509-9700 ext.312
################################################################
|
|
|