Matt, non wetting of a pad or land after HASL is very possible. My
guess is the large areas had exposed CU on reciept. In the areas around
the annular ring, may be a little Solder mask "bleed-out" or other
Solder mask related issue. The chances of somethin chompin it off
during component attachment is slim.
Hope this helps,
Mark Simmons
################################################################
TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe: SUBSCRIBE TechNet <your full name>
To unsubscribe: SIGNOFF TechNet
################################################################
Please visit IPC's web site (http://www.ipc.org) "On-Line Services" section for additional information.
For technical support contact Hugo Scaramuzza at [log in to unmask] or 847-509-9700 ext.312
################################################################