The book The Mechanics of Solder Alloy Interconnects edited by Darrel
Frear et.al.
is worth reading. The book was published by Van Nostrand Reinhold, USA.
Chapter 8 is named Applications - Through Hole.
However, in our company we have the rule of thumb that the wall of
solder in a PTH should be kept within 2 - 5/10 mm on average.
A thinner wall may lead to brittle solder joint - most likely because of
intermetallics.
A thicker wall tends to be less strong also - most likely because of the
relatively large amount of "soft" solder alloy in the interconnection.
Best regards
Svend
################################################################
TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe: SUBSCRIBE TechNet <your full name>
To unsubscribe: SIGNOFF TechNet
################################################################
Please visit IPC's web site (http://www.ipc.org) "On-Line Services" section for additional information.
For technical support contact Hugo Scaramuzza at [log in to unmask] or 847-509-9700 ext.312
################################################################