Paul,

Typical insertion times for components can be calculated using MTM, MOST,
etc (Note: These are acronyms for Engineered Time Standard analysis). These
methods will give very accurate results depending on what exactly you are
trying to do.

For Example, An operator seated at a bench on a slide line or paced line
reaching for a standard resistor in a bin within reach installing the part
into a PC board would result in an engineered analysis of 3.23 seconds per
insertion. Notice however, the details in the action. Note that the operator
was sitting, no swiveling, standing etc. Note that the operator had the
workpiece in front of him (her). Note that the resistor was located in an
open bin within reach. Note that the operator knew where the part was going,
no reading of prints etc etc etc. This kind of analysis can actually drive
you nuts.

However, for purposes of an approximation, the thing that you need to do is,
go out to your shop floor area. Analyze by observation the method that is
most respresentative of your standard practice, and note the number of
insertions made over a given time period. You don't need to stand with a
stop watch, this tends to aggrevate people. Just kinda glance at your watch.
You'll then get what you are looking for. For purposes of estimations I use
insertion times of 15 - 30 seconds per part depending on the part.  (Note to
Tech-Netters, don't blast me for how outrageous these times are, the times
given take into account the standard practices employed at this particular
facility.)

If you would like to discuss off-line I'd be happy to help. I will not offer
any attachments, manuals or whatever. (I cannot support an e-mail barrage
suffered by Jerry C with his "Cause and Effect" diagrams)

Bill Kasprzak
Moog Inc.
716-652-2000 ext 2507
[log in to unmask]

################################################################
TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe:   SUBSCRIBE TechNet <your full name>
To unsubscribe:   SIGNOFF TechNet 
################################################################
Please visit IPC's web site (http://www.ipc.org) "On-Line Services" section for additional information.
For technical support contact Hugo Scaramuzza at [log in to unmask] or 847-509-9700 ext.312
################################################################