Mime-Version: |
1.0 |
Sender: |
|
X-To: |
|
Date: |
Thu, 9 Jul 1998 20:03:57 -0400 |
Reply-To: |
|
Subject: |
|
From: |
|
Content-Transfer-Encoding: |
7bit |
Organization: |
Applied CAD Knowledge Inc |
Content-Type: |
text/plain; charset=us-ascii |
Parts/Attachments: |
|
|
Richard List wrote:
>
> With flex design and manufacturing becoming main stream its about time
> the rigid board software guys design a package for flex design and
> manufacturing solutions.
>
FWIW, Allegro has some reasonable features as far as
flex design goes, filleting of pads and t-junctions,
works well with radii, good database, DRC, and post-
processing.
And they've now got a lower-cost layer-restricted version.
Still a deep and perhaps expensive tool, but we've had
reasonable luck at least with moderate flex and rigid-
flex stuff. Not perfectly native in the flex sense but
not bad for a "rigid" system....
--
Jeff Seeger Applied CAD Knowledge Inc
Chief Technical Officer Tyngsboro, MA 01879
jseeger "at" appliedcad "dot" com 978 649 9800
################################################################
TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe: SUBSCRIBE TechNet <your full name>
To unsubscribe: SIGNOFF TechNet
################################################################
Please visit IPC's web site (http://www.ipc.org) "On-Line Services" section for additional information.
For technical support contact Hugo Scaramuzza at [log in to unmask] or 847-509-9700 ext.312
################################################################
|
|
|