 
| Content-Transfer-Encoding: |
7bit |
| Sender: |
|
| Subject: |
|
| From: |
|
| Date: |
Fri, 24 Jul 1998 18:40:09 -0400 |
| Content-Type: |
text/plain; charset=us-ascii |
| MIME-Version: |
1.0 |
| Reply-To: |
|
| Parts/Attachments: |
|
|
We have a number of boards that we hand apply a peelable solder mask in
areas where components are added after wave soldering. Recently, I saw a
board that had a screened peelable solder mask that had been applied by
the board vendor. Does anyone have any experience with using this type
of mask? I've checked with one of our vendors and although he doesn't
use peelable mask, he has seen such a product and is willing to run some
samples. Any feedback would be greatly appreciated!
Mike Blackburn
Sr. Designer
Novar Controls Corp.
Copley, OH 44321
(330) 670-1010, Ext. 5584
################################################################
DesignerCouncil E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe: SUBSCRIBE DesignerCouncil <your full name>
To unsubscribe: SIGNOFF DesignerCouncil
################################################################
Please visit IPC's web site (http://www.ipc.org) "On-Line Services" section for additional information.
For technical support contact Hugo Scaramuzza at [log in to unmask] or 847-509-9700 ext.312
################################################################
|
|
|
