Mime-Version: |
1.0 |
Sender: |
|
X-To: |
|
Date: |
Tue, 7 Jul 1998 10:44:04 -0500 |
Reply-To: |
|
Subject: |
|
From: |
|
In-Reply-To: |
<c=US%a=_%p=Electromagnetic_%l=NT_EXLXE-980707124200Z-7216@
nt_exems.elmg.com> |
Content-Type: |
text/plain; charset="us-ascii" |
Parts/Attachments: |
|
|
At 08:42 AM 7/7/98 -0400, you wrote:
>Greetings Frank,
Chris, Great help and good contacts. Just what I needed. I am not
looking at the ZIF connectors, rather a small SMT connector that is
normally used on rigid boards for a special computer application. I spoke
with Paul Kopnick (Larry is no longer with them) at All Flex earlier today.
He commented that your notes etc. were about the best they recieved in,
and said if I wanted a good starting spot on the correct material callouts
etc. that I should contact you..... I was attempting to get a "template"
from him on the typical areas he needed to have specified. So whats the
chance I could get a set of notes from you on one of your flex boards.
################################################################
DesignerCouncil E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe: SUBSCRIBE DesignerCouncil <your full name>
To unsubscribe: SIGNOFF DesignerCouncil
################################################################
Please visit IPC's web site (http://www.ipc.org) "On-Line Services" section for additional information.
For technical support contact Hugo Scaramuzza at [log in to unmask] or 847-509-9700 ext.312
################################################################
|
|
|