Needs some help on flex circuit design. It has been a long time since my
last flex circuit, and I am looking for some input to good fabrication
facilities as well as reasonable spacing and width specs to expect. Any
input would be appreciated.
In particular, I am looking at a ribbon connector type arrangement
(straight pin to pin connections) with trace widths in the 8-10 mil range
and pad clearances as small as .012 mil....... Does this sound like
something some of you are already doing? I'm looking at a product that
will run in the 50-100 lot per month quantities.
Thanks in advance for any input.
################################################################
DesignerCouncil E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe: SUBSCRIBE DesignerCouncil <your full name>
To unsubscribe: SIGNOFF DesignerCouncil
################################################################
Please visit IPC's web site (http://www.ipc.org) "On-Line Services" section for additional information.
For technical support contact Hugo Scaramuzza at [log in to unmask] or 847-509-9700 ext.312
################################################################