Could someone enlighten me on how the hole to lead ratios for through
hole technology was derived in IPC-D-275?
Specifically, does it;
consider automated placement or manual insertion?
consider hand assembly, wave solder, reflow solder, or any?
Thank you very much, Rich.
[log in to unmask] - NEW ADDRESS!
################################################################
TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe: SUBSCRIBE TechNet <your full name>
To unsubscribe: SIGNOFF TechNet
################################################################
Please visit IPC's web site (http://www.ipc.org) "On-Line Services" section for additional information.
For technical support contact Hugo Scaramuzza at [log in to unmask] or 847-509-9700 ext.312
################################################################