Following mail was posted by Russ M on June 23, 1998 at 11:27:37: to
http://www.smtnet.com/smt_forum/smt_mail.html
Has anyone seen/used these yet? They seem to have lower
coefficient of friction
for release of paste and less wear and tear as well as
conforming to the board better
(plastic has better memory than stainless). Also there is no mesh
so a larger
image can be put in a smaller stencil size. But, the best is that
you can see through
the stencil for manual and semi-automatic printer alignment and
reduce set up and changeover times.
Anyone familiar with these?
How long do they last?
---------------------------------------------------------------------------
----------------------------------------------------------
Any comments ?
brs, Johannes
################################################################
TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe: SUBSCRIBE TechNet <your full name>
To unsubscribe: SIGNOFF TechNet
################################################################
Please visit IPC web site (http://jefry.ipc.org/forum.htm) for additional information.
For technical support contact Hugo Scaramuzza at [log in to unmask] or 847-509-9700 ext.312
################################################################