Hi Mark,
If you can dxf out than there are a few more "steps " you can take.
Hijaak Pro software can translate dxf to iges. So does Okinos Polytrans
software. It is best to try before you buy or send your output  dxf to
the company, let them translate it and send it back to you. You can then
test it by importing it into your iges based software. You are entering
a kinda different world where 2-D and 3-D graphic packages will not
always mesh cleanly. So beware.

Good Luck,
Jim W.

> -----Original Message-----
> From: Scott D. Shepard [SMTP:[log in to unmask]]
> Sent: Tuesday, June 23, 1998 11:37 AM
> To:   [log in to unmask]
> Subject:      Re: [DC] IGES vs. ORCAD
>
> I have used Orcad Layout v7.10, there were no IGES import or export
> capabilities that I could find. Only DXF.
>
> Scott
>
>
> Mark Radley wrote:
> >
> > Good Morning.
> >
> > Is anyone familiar with creating IGES output from ORCAD Capture and
> Layout database ?
> > How many software hoops do we have to jump through ?
> >
> > Thanks
> >
> > RPA Electronics Design, LLC
> > 1285 Chenango Street                   phone: (607) 771-0393
> > Binghamton, NY 13901                      fax:      (607) 771-0658
> >
> > Mark Radley
> > email: [log in to unmask]  http://www.rpaeng.com
> >
> > ################################################################
> > DesignerCouncil E-Mail Forum provided as a free service by IPC using
> LISTSERV 1.8c
> > ################################################################
> > To subscribe/unsubscribe, send a message to [log in to unmask] with
> following text in the body:
> > To subscribe:   SUBSCRIBE DesignerCouncil <your full name>
> > To unsubscribe:   SIGNOFF DesignerCouncil
> > ################################################################
> > Please visit IPC web site (http://jefry.ipc.org/forum.htm) for
> additional information.
> > For technical support contact Hugo Scaramuzza at [log in to unmask] or
> 847-509-9700 ext.312
> > ################################################################
>
> ################################################################
> DesignerCouncil E-Mail Forum provided as a free service by IPC using
> LISTSERV 1.8c
> ################################################################
> To subscribe/unsubscribe, send a message to [log in to unmask] with
> following text in the body:
> To subscribe:   SUBSCRIBE DesignerCouncil <your full name>
> To unsubscribe:   SIGNOFF DesignerCouncil
> ################################################################
> Please visit IPC web site (http://jefry.ipc.org/forum.htm) for
> additional information.
> For technical support contact Hugo Scaramuzza at [log in to unmask] or
> 847-509-9700 ext.312
> ################################################################

################################################################
DesignerCouncil E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe:   SUBSCRIBE DesignerCouncil <your full name>
To unsubscribe:   SIGNOFF DesignerCouncil 
################################################################
Please visit IPC web site (http://jefry.ipc.org/forum.htm) for additional information.
For technical support contact Hugo Scaramuzza at [log in to unmask] or 847-509-9700 ext.312
################################################################