Subject: | |
From: | |
Reply To: | TechNet E-Mail Forum. |
Date: | Thu, 25 Jun 1998 08:09:33 +-300 |
Content-Type: | multipart/mixed |
Parts/Attachments: |
|
|
Dave
You can use the same markers used in AOI for marking the boards, it seems they do the job and are pretty well removable.
David Banitt
----------
From: Dave Pick -"process engineer"[SMTP:[log in to unmask]]
Sent: יום חמישי, יוני 25, 1998 03:10
To: [log in to unmask]
Subject: [TN] defect marking
I am looking for a temporary way to mark defects on a PCB assembly (other than
the red arrows that everyone uses). The boards will go back through a water
wash, so I was thinking a water soluable, non-conductive ink would be nice. Are
there any recommendations?
################################################################
TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe: SUBSCRIBE TechNet <your full name>
To unsubscribe: SIGNOFF TechNet
################################################################
Please visit IPC web site (http://jefry.ipc.org/forum.htm) for additional information.
For technical support contact Hugo Scaramuzza at [log in to unmask] or 847-509-9700 ext.312
################################################################
|
|
|