Content-Transfer-Encoding: 7bit
What we did in a previous incarnation is to use one of the several
commercial DFM guides available as the basis. Then we wrote an
exception document to supplement it. It makes life much easier than
writing the whole thing yourself.
______________________________ Reply Separator _________________________________
Subject: [TN] GEN:DFM
Author: [log in to unmask]> Larry Davis <[log in to unmask] at
internet
Date: 6/2/98 8:07 AM
We are trying to write a Design for Manufacturability assembly and test
specification and were wondering if anyone out there that has been down
this road has any advice for us. Possibly even sharing your document so
that we can see how it is set up and what it encompasses.
Thanks in advance for your help!
Larry Davis
WGC
Ft. Collins, CO
970-498-3298
################################################################
TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text
in the body:
To subscribe: SUBSCRIBE TechNet <your full name>
To unsubscribe: SIGNOFF TechNet
################################################################
Please visit IPC web site (http://jefry.ipc.org/forum.htm) for additional
information.
For technical support contact Hugo Scaramuzza at [log in to unmask] or 847-509-9700
ext.312
################################################################
################################################################
TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe: SUBSCRIBE TechNet <your full name>
To unsubscribe: SIGNOFF TechNet
################################################################
Please visit IPC web site (http://jefry.ipc.org/forum.htm) for additional information.
For technical support contact Hugo Scaramuzza at [log in to unmask] or 847-509-9700 ext.312
################################################################