My name is Rob Carver at Harrington Signal Inc. in Moline Illinois.
Our Quality Assurance Supervisor recently quit and the inspectors have a
question that I as a ISO manager cannot answer, so I'll post a message.
The question is must wires that are soldered directly to PCB assemblies
be:
a. Pre-tinned??
b. Have both top and bottom side solder and the correct percentage
of fill.
The IPC book doesn't really address this point.
Rob Carver
Harrington Signal Inc.
2519 4th Avenue
Moline, Illinois 61265
1-800-577-5758
[log in to unmask]
################################################################
TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe: SUBSCRIBE TechNet <your full name>
To unsubscribe: SIGNOFF TechNet
################################################################
Please visit IPC web site (http://jefry.ipc.org/forum.htm) for additional information.
For technical support contact Hugo Scaramuzza at [log in to unmask] or 847-509-9700 ext.312
################################################################