Subject: | |
From: | |
Reply To: | TechNet E-Mail Forum. |
Date: | Tue, 5 May 1998 18:19:58 -0400 |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
HI Ken,
There are a few questions you need to fill in the blanks for before calculation can be done:
1) How many layers
2) What is the stackup? I.E. sig, grd, pwr, sig???
3) what is the base copper
4) what layers are Impedance controlled?
5) what is the target line width on the impedance layers?
6) what is the Er of the material (this will change based on the prepreg style/glass to resin
ratio)
7) are the lines differential (typically identified by 2 circuits running parallel with each
other)
8) Is there a plane under the impedance lines? (sounds silly, but need to know).
9) What is your tolerance on the impedance +-10%?
10) Will you be testing and with what type of coupon?
There are quite a few programs available for calculation that will meet your needs. and the above
is necessary to insure accuracy. If you Email me, I can help with some of the numbers. JOHN
WAITE.
Ken Patel wrote:
> Can some provide me common layer stack-ups for a board of 1.6 +/- 0.2 mm
> thickness, keeping in mind signal impedance control of ~50 Ohm with high Tg
> FR4 material?
>
> re,
> ken patel
> ______________________________________________________
> Ken Patel Phone: (408) 490-6804
> 1708 McCarthy Blvd. Fax: (408) 490-6859
> Milpitas, CA 95035 Beeper: (888) 769-1808
>
> ################################################################
> TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
> ################################################################
> To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
> To subscribe: SUBSCRIBE TechNet <your full name>
> To unsubscribe: SIGNOFF TechNet
> ################################################################
> Please visit IPC web site (http://jefry.ipc.org/forum.htm) for additional information.
> For the technical support contact Dmitriy Sklyar at [log in to unmask] or 847-509-9700 ext.311
> ################################################################
################################################################
TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe: SUBSCRIBE TechNet <your full name>
To unsubscribe: SIGNOFF TechNet
################################################################
Please visit IPC web site (http://jefry.ipc.org/forum.htm) for additional information.
For the technical support contact Dmitriy Sklyar at [log in to unmask] or 847-509-9700 ext.311
################################################################
|
|
|