Mime-Version: |
1.0 |
Sender: |
|
Subject: |
|
From: |
|
Date: |
Fri, 8 May 1998 11:55:24 PDT |
Content-Transfer-Encoding: |
quoted-printable |
Content-Type: |
text/plain; charset=US-ASCII; X-MAPIextension=".TXT" |
Reply-To: |
|
Parts/Attachments: |
|
|
Folks.
Appologies for the previous 'no heading' message
We have had a load of assembled PCB's in from a new supplier.
trouble is they are not to drawing and i'm being asked if we can accept them. The problem is that
we have a flying lead connected to two through hole pillars. The drawing requires a 270 degree hook
on the wire before it is soldered to the post. The subbies have soldered the wire parallel to the post (straight up and down)
Question: is this as good as the requested hook method
:will there be reliability problems in the future
:would vibration /shock tests be required to prove the deviation is acceptable
:should we just reurn to the subbie for correctio ;to drawing'
any help 'donations' gratefully accepted
Regards
Ian Squires
Senior Production Engineer
-------------------------------------------------------
Graseby Dynamics Ltd
Park Avenue, Bushey, Watford, Herts, WD2 2BW
Web Site: www.gradyn.co.uk
Phone: 01923-228566 xt 295
Fax: 01923-221361
E-mail: [log in to unmask]
Registered in England no. 480992
Registered office:
765 Finchley Road, London, NW11 8DS
-------------------------------------------------------
################################################################
TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe: SUBSCRIBE TechNet <your full name>
To unsubscribe: SIGNOFF TechNet
################################################################
Please visit IPC web site (http://jefry.ipc.org/forum.htm) for additional information.
For the technical support contact Dmitriy Sklyar at [log in to unmask] or 847-509-9700 ext.311
################################################################
|
|
|