Subject: | |
From: | |
Reply To: | TechNet E-Mail Forum. |
Date: | Thu, 21 May 1998 02:40:32 -0400 |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
Mirka Halas wrote:
>
> Hello Designers,
> I am in process of converting from Gerber 274 to 274X,
> and I opened
> can of warms, which is called thermal reliefs.
> So far we used thermal relief and antipads developed by the rule of
> thumb, that it should be oversized by 20 mils from the pad.
> I would like to understand the calculation, and where I can shrink
> the dimensions to get
> more plane surface for our high speed boards.
> I read IPC-D-275,IPC-2221 and IPC-2222, and do not see calculation for
> the outside diameter
> of thermal relief. 60% of the land is calculated for the web width,
> but what is the hight of the web?
Karl's response is probably the best analysis I've
seen on the characteristics of the thermal relief, "but"
> Is it the same as the diameter of Clearance area in planes?
> Is IPC's calculation for the clearance area in planes too conservative.
> One manufacturer can do
> minimum antipads with diameter of the drill plus .016".
>
Minimum per the drill size, per your vendor's capability
(.016 would be reduced producibility in many shops), but
maximum should be smaller than:
(Pos pad) + 2*(pos trace spacing) - 2*(registration allowance)
You really don't want to allow the signal wires to sneak
plane clearance underneath them on a high speed design.
This applies to the outer diameter of your thermal as
well - suddenly even the simplest pad geometry gets pretty
darn complicated, huh?
--
Jeff Seeger Applied CAD Knowledge Inc
Chief Technical Officer Tyngsboro, MA 01879
jseeger "at" appliedcad "dot" com 978 649 9800
################################################################
TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe: SUBSCRIBE TechNet <your full name>
To unsubscribe: SIGNOFF TechNet
################################################################
Please visit IPC web site (http://jefry.ipc.org/forum.htm) for additional information.
For technical support contact Hugo Scaramuzza at [log in to unmask] or 847-509-9700 ext.312
################################################################
|
|
|