Subject: | |
From: | |
Reply To: | TechNet E-Mail Forum. |
Date: | Tue, 19 May 1998 07:21:23 +0900 |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
Dear Technetters:
We have tried to check the vibration level of a drill room. We used FFT
Analyzer made by AFK Condition Monitoring System. We checked the vibration
level on a work table of a drill machine. It was around 0.5 to 2.5 micron
meters when the machine and the surrounding ones were off, and it was around
3.5 to 7 micron meters in plane direction and 1.5 to 3 micron meters in Z
direction when all the machine were running.
However I am not sure whether the vibration level observed is to be improved
or not. Please do advise me on the recommended maximum level of
vibration for small hole drilling.
Thanks and regards,
M. C. Chu
CSS Asia Co., Ltd.
Tel: 82-2-523-8810
Fax: 82-2-523-1483
E-Mail: [log in to unmask]
################################################################
TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe: SUBSCRIBE TechNet <your full name>
To unsubscribe: SIGNOFF TechNet
################################################################
Please visit IPC web site (http://jefry.ipc.org/forum.htm) for additional information.
For technical support contact Hugo Scaramuzza at [log in to unmask] or 847-509-9700 ext.312
################################################################
|
|
|