Mime-Version: |
1.0 |
Sender: |
|
Subject: |
|
From: |
|
Date: |
Thu, 21 May 1998 09:17:32 -0700 |
Content-Type: |
text/plain |
Reply-To: |
|
Parts/Attachments: |
|
|
I don't think you can eliminate it no matter what you do with the
wave profile or some other fancy tricks. My best advise is "hand
solder the BNC connector" Or you may try it by isolating the
ground pin from the board ground plane (use cross-shape
geometry pad).
re
Mpark
NII-Norsat International Inc.
>>> Donal O Brien <[log in to unmask]> May 21, 1998
8:45 am >>>
Hi technetters,
I have a problem at wave solder with spikes on a BNC
connector.
The spikes are on the ground pins which are 1.6mm diameter
protruding 1.4
mm with a flat surface. The land diameter is only.4mm which
may be causing
a problem..
we use turbulent to heat the part to some effect but does not
clear the
problem entirely.
any clues
Rgds
Donal o Brien
################################################################
TechNet E-Mail Forum provided as a free service by IPC using
LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to
[log in to unmask] with following text in the body:
To subscribe: SUBSCRIBE TechNet <your full name>
To unsubscribe: SIGNOFF TechNet
################################################################
Please visit IPC web site (http://jefry.ipc.org/forum.htm) for
additional information.
For technical support contact Hugo Scaramuzza at
[log in to unmask] or 847-509-9700 ext.312
################################################################
################################################################
TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe: SUBSCRIBE TechNet <your full name>
To unsubscribe: SIGNOFF TechNet
################################################################
Please visit IPC web site (http://jefry.ipc.org/forum.htm) for additional information.
For technical support contact Hugo Scaramuzza at [log in to unmask] or 847-509-9700 ext.312
################################################################
|
|
|