Hi technetters ,
I sent this question several days ago . I had problems with my e-mail , so I
do not know if this message was distributed properly .
We are considering lamination of heat sink on PCB with Electroless Nickel
Immersion Gold ( ENIG ) finishing . What is practical experience with such
process ??
Lamination on Nickel should not be a problem , but what about lamination on
Immersion Gold??
Regards
Edward Szpruch
Eltek Ltd - Israel
Tel 972 3 9395050
Fax 972 3 9309581
E-mail : [log in to unmask]
################################################################
TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe: SUBSCRIBE TechNet <your full name>
To unsubscribe: SIGNOFF TechNet
################################################################
Please visit IPC web site (http://jefry.ipc.org/forum.htm) for additional information.
For technical support contact Hugo Scaramuzza at [log in to unmask] or 847-509-9700 ext.312
################################################################