Anthony:

Generally speaking we do not coat under the area where extractors are
mounted. The primary reasons are to allow the extracators  to move freely
and to prevent the coating from flaking off. Typically a board is mounted in
a chassis, if coating was under the extractors  a piece of coating could
come loose and drop to the botttom of the chassis and lodge itself into an
undesireable location, like a mating connector !

Bill Kasprzak
Moog Inc.

################################################################
TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe:   SUBSCRIBE TechNet <your full name>
To unsubscribe:   SIGNOFF TechNet 
################################################################
Please visit IPC web site (http://jefry.ipc.org/forum.htm) for additional information.
For the technical support contact Dmitriy Sklyar at [log in to unmask] or 847-509-9700 ext.311
################################################################