Any guidance on the reasonableness and cost-efficient producibility of
the following callout for connector location on a PWB?
<Connector pin contact pattern shall be symmetrical to the
center line of the PWB within .005">
Also, if the tolerance were relaxed to .010" would most cardrack designs
be able to compensate?
Thanks
Dennis Guy-Sell
[log in to unmask]
################################################################
TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe: SUBSCRIBE TechNet <your full name>
To unsubscribe: SIGNOFF TechNet
################################################################
Please visit IPC web site (http://jefry.ipc.org/forum.htm) for additional information.
For the technical support contact Dmitriy Sklyar at [log in to unmask] or 847-509-9700 ext.311
################################################################