Hello All,

I need help. We have just had a customer of ours ask us to bid a flexible
circuit job. We haven't done flexible circuits yet, so I need some info on
the process. The circuit I'm looking at is a 4-layer
(Dielectric--Conductive-Conductive--Dielectric) flex board. The substrate is
a polyvinyl chloride material and is .015 thick. It appears that the only
components that need to be added are 2 through hole connectors.  What do I
need to watch out for to run this board through my Soltec Wave Solder(If its
even possible).The production volumes are fairly high so hand soldering is
pretty much out of the question. Any info on flex circuit assembly would be
greatly appreciated. Also, does anyone have any experience with running
surface mount flexible circuits on Zevatech 700 series machines.

thanks

Tim Stammely
Manufacturing Engineer
Manufacturing Services & Integration (MSI)
Manassas, VA

################################################################
TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe:   SUBSCRIBE TechNet <your full name>
To unsubscribe:   SIGNOFF TechNet 
################################################################
Please visit IPC web site (http://jefry.ipc.org/forum.htm) for additional information.
For the technical support contact Dmitriy Sklyar at [log in to unmask] or 847-509-9700 ext.311
################################################################