> Greetings;
> Would someone with a copy of IPC-T-50 please tell me what the diff is
> between an unsupported hole and a supported hole?
> Thank you
>
>
After reading the T-50 definitions on these, my impression is it is
referring to plated and nonplated holes.
*************************************************
Thanks
Walter L. Williams, Circuit Board Designer
I-O Corporation, SLC, Utah
Industry leader in IBM AS400 connectivity products
[log in to unmask]
Voice: 1-801-972-3558 ex 123
Alternate: 1-801-973-6767
*************************************************
Carpe Diem
################################################################
DesignerCouncil E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe: SUBSCRIBE DesignerCouncil <your full name>
To unsubscribe: SIGNOFF DesignerCouncil
################################################################
Please visit IPC web site (http://jefry.ipc.org/forum.htm) for additional information.
For the technical support contact Dmitriy Sklyar at [log in to unmask] or 847-509-9700 ext.311
################################################################