Sender: |
|
Date: |
Tue, 14 Apr 1998 08:00:09 -0700 |
Reply-To: |
|
Content-type: |
text/plain; charset="US-ASCII" |
Subject: |
|
MIME-Version: |
1.0 |
Content-transfer-encoding: |
7bit |
Organization: |
I-O Corporation |
From: |
|
Parts/Attachments: |
|
|
> I am using Pads for PCB design, I would like to save some time on the Bill of material creation.
> The problem is that my current BOM is done in MS Words and every time I have to generate
> a part list report from Pads and re-key in everything in Words, a lot time was wasted especially
> in the part no. creation for different parts used.
> Any body have a better way to do it ?
> Thanks & Best Regards,
>
Hello Eileen
Do you still have the manual which came with V1 of your Power PCB? If
you do, go to page 48-53 of that manual, and there you find a section
on "User defined reports". This section will assist you in formating
a custom report file. If you dont have the manual try the on line
help(?) . I havent seen the on line help on this subject so I dont
how complete it is. I took one of the exsisting files and modified it
to suite me and saved it under a different name. These report format
files can be found the c:\padspwr\powerpcb directory. The output from
these report files are often called "REPORT.REP" and are, I beleive,
put in this same directory. you can take your report file output and
bring it up in your MS Word and mod it from there.
Hope this helps..
*************************************************
Thanks
Walter L. Williams, Circuit Board Designer
I-O Corporation, SLC, Utah
Industry leader in IBM AS400 connectivity products
[log in to unmask]
Voice: 1-801-972-3558 ex 123
Alternate: 1-801-973-6767
*************************************************
Carpe Diem
################################################################
DesignerCouncil E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe: SUBSCRIBE DesignerCouncil <your full name>
To unsubscribe: SIGNOFF DesignerCouncil
################################################################
Please visit IPC web site (http://jefry.ipc.org/forum.htm) for additional information.
For the technical support contact Dmitriy Sklyar at [log in to unmask] or 847-509-9700 ext.311
################################################################
|
|
|