I am using Pads for PCB design, I would like to save some time on the Bill of material creation.
The problem is that my current BOM is done in MS Words and every time I have to generate
a part list report from Pads and re-key in everything in Words, a lot time was wasted especially
in the part no. creation for different parts used.
Any body have a better way to do it ?
Thanks & Best Regards,
################################################################
DesignerCouncil E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe: SUBSCRIBE DesignerCouncil <your full name>
To unsubscribe: SIGNOFF DesignerCouncil
################################################################
Please visit IPC web site (http://jefry.ipc.org/forum.htm) for additional information.
For the technical support contact Dmitriy Sklyar at [log in to unmask] or 847-509-9700 ext.311
################################################################