Sender: |
|
Subject: |
|
From: |
|
Date: |
Wed, 8 Apr 1998 09:28:39 -0700 |
X-To: |
|
Reply-To: |
|
Parts/Attachments: |
|
|
We use many BGA's on our boards. The majority
of them are on a 50 mil pad pitch. We are
just now starting to use the 1 mm pad pitch
devices. The 50 mil parts range from 192 pins
to 1088. the 1 mm parts range from 824 to
1270. All of our BGA's use a dogbone shaped
pad. One end of the dogbone is for device
attachment. The other end performs a via on
a stringer function. The designer never needs
to create a breakout pattern. As far as the
designer is concerned the BGA looks like a
through-hole part and I've controlled the
routing so that only the through-hole part of
the pin accepts a connect line. No connect lines
can go to the BGA pad. On the 50 mil parts the
bottom pad is large enough for test to use as
a test point. The 1 mm don't allow this convenience.
O BGA attachment pad section
// Copper connect section
o Through-hole section
This pad was designed to benefit rework, manufacturing,
design, and test.
################################################################
DesignerCouncil E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe: SUBSCRIBE DesignerCouncil <your full name>
To unsubscribe: SIGNOFF DesignerCouncil
################################################################
Please visit IPC web site (http://jefry.ipc.org/forum.htm) for additional information.
For the technical support contact Dmitriy Sklyar at [log in to unmask] or 847-509-9700 ext.311
################################################################
|
|
|