Technet:
For PWAs that require connecters fastened with hardware
(screws/lockwashers) to the
FR-4, is there an acceptable torque setting requirement that will not
damage the
FR-4? These are usually 2-56 or 4-40, but will standard torque for these
sizes damage the FR-4 in any way??
Should it just be tighten firmly and use locktite to secure it?
Curious to know if there is a standard method for doing this attach and
secure.
Any information appreciated.
Regards........DT
################################################################
TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe: SUBSCRIBE TechNet <your full name>
To unsubscribe: SIGNOFF TechNet
################################################################
Please visit IPC web site (http://jefry.ipc.org/forum.htm) for additional information.
For the technical support contact Dmitriy Sklyar at [log in to unmask] or 847-509-9700 ext.311
################################################################