Subject: | |
From: | |
Reply To: | TechNet E-Mail Forum. |
Date: | Mon, 23 Mar 1998 06:47:37 +0300 |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
At 17:12 20/03/98 -0500, you wrote:
> Can reasonably good results be achieved with electroless nickel or
other
>metals using typical laboratory equipment such as hot plates and pyrex
>glassware? If so, where can I buy small quantities of supplies? I need to
>metalize a few ceramic pieces from time to time, but am not aware of a
>plating shop in my area that will do small jobs.
>_________________________________________________________________________
James !
Sure You can do it lab conditions . But You have to assure good stirring ,
clean and new glassware without any scraches . Nickel electroless is
sensitive to overheating . As well put Your attention on quick depletion of
chemistry while plating .
I thing You can buy this stuff in from supplier of laboratory equipment .
Suppliers of the chemistry : Atotech , Lea-Ronal , Enthon , MacDermid etc
My advice - buy it incognito , otherwise under NASA name and its incoming
inspection procedures , COC , COA etc it will cost You a fortune !!!
Good lack and have fun !
Edward
Edward Szpruch
Eltek Ltd - Israel
Tel 972 3 9395050
Fax 972 3 9309581
E-mail : [log in to unmask]
################################################################
TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe: SUBSCRIBE TechNet <your full name>
To unsubscribe: SIGNOFF TechNet
################################################################
Please visit IPC web site (http://jefry.ipc.org/forum.htm) for additional information.
For the technical support contact Dmitriy Sklyar at [log in to unmask] or 847-509-9700 ext.311
################################################################
|
|
|