TECHNET Archives

March 1998

TechNet@IPC.ORG

Options: Use Monospaced Font
Show Text Part by Default
Show All Mail Headers

Message: [<< First] [< Prev] [Next >] [Last >>]
Topic: [<< First] [< Prev] [Next >] [Last >>]
Author: [<< First] [< Prev] [Next >] [Last >>]

Print Reply
Subject:
From:
Mitch Morey <[log in to unmask]>
Reply To:
TechNet E-Mail Forum.
Date:
Tue, 3 Mar 1998 10:28:11 -0800
Content-Type:
text/plain
Parts/Attachments:
text/plain (62 lines)
Hi Jack,

You must be using the Cadence tools for your analysis (hee hee). It
defaults to the same values. I have been using 4.3-4.5 for my
controlled impedance measurements and have been quite accurate
with deteremining trace widths and layer separation that our fab
house could confirm.

I have used an impedance calculator from IUD in the past that uses
ranges that you have talked about, but for standard FR4 material I
still revert back to 4.3-4.5

BTW, which INTEL do you work at, if you don't mind me asking? I've done
some work for INTEL, Hillsboro and they always seemed to knowthese
values.

Good luck,

Mitch Morey
Sr. PCB Designer
ComStream Corp

>>> "Olson, Jack C" <[log in to unmask]> 03/03/98 09:21am >>>
WARNING: this is a very unexciting question...

My software does some basic signal integrity analysis,
and I just noticed it defaults the dielectric constant for
regular FR4 to 4.7

I was under the impression that most FR4 is at 4.2-4.3
these days (more resin? thinner cores? can't remember...)

Even a brief response will be appreciated!
                                                                Jack

################################################################
DesignerCouncil E-Mail Forum provided as a free service by IPC using
LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with
following text in the body:
To subscribe:   SUBSCRIBE DesignerCouncil <your full name>
To unsubscribe:   SIGNOFF DesignerCouncil
################################################################
Please visit IPC web site (http://jefry.ipc.org/forum.htm) for additional
information.
For the technical support contact Dmitriy Sklyar at [log in to unmask] or
847-509-9700 ext.311
################################################################

################################################################
TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe:   SUBSCRIBE TechNet <your full name>
To unsubscribe:   SIGNOFF TechNet 
################################################################
Please visit IPC web site (http://jefry.ipc.org/forum.htm) for additional information.
For the technical support contact Dmitriy Sklyar at [log in to unmask] or 847-509-9700 ext.311
################################################################


ATOM RSS1 RSS2