Ok, How many of you (board fab vendors) are using Kester
5631-C2 Protecto as OSP coating for pcb? I read Kester OSP
technical spec. 10 times comparing with Entek Plus 106A. It
appears that applying Kester OSP as a final board finish is much
simpler and easier. That makes me believe that any board
assembly shop can setup a couple of dip tanks and apply the
OSP coating with a min cost and training. Or am I being misled
by the spec?
Your inputs are very much appreciated.
Mpark
NII Norsat International Inc.
################################################################
TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe: SUBSCRIBE TechNet <your full name>
To unsubscribe: SIGNOFF TechNet
################################################################
Please visit IPC web site (http://jefry.ipc.org/forum.htm) for additional information.
For the technical support contact Dmitriy Sklyar at [log in to unmask] or 847-509-9700 ext.311
################################################################