The one down side of adhesive cleaning is the operating cost of the
rollers. Depending on the operation the replacement rollers can run into
some money.

ElectroStatics make cleaners which removed static electricity and then
clean with compressed air and vacuum and do not use adheasive rollers.

View picture @


http://www.electrostatics.com/sheetcleaning.htm


Will you be at the IPC show in April?


At 01:14 PM 03/11/98 +0000, you wrote:
>Edward Szpruch wrote:
>>We are considering cleaning of innerlayers by adhesive rollers just before
>>lay-up . We are applying reduced black oxide , 0.4 mg/sqcm . AOI is done
>>before black oxide .
>>We allready made preliminary test and we had no problems with delaminations
>>etc . My questions are :
>>1 ) Does anyone performing similar kind of cleaning after black oxide ?
>>2 ) What kind of negative effects should be exepcted ? ....
>
>Edward
>
>We use adhesive rollers before lay-up but never after black oxide.
>The surface is clean after black oxide so it's not necessary to clean it
again.
>We have also tested it and we had problems with delamination.
>
>Best regards
>
>Simon
>
>---------------------------------------------------------------------------
---------
>Optiprint AG
>Simon Huetter           Tel.:   +41 71 878 77 77
>Dipl. El. Ing. HTL      Fax.:   +41 71 878 77 66
>R&D                     e-mail:  [log in to unmask]
>---------------------------------------------------------------------------
---------
>http://www.optiprint.ch
>---------------------------------------------------------------------------
---------
>
>################################################################
>TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
>################################################################
>To subscribe/unsubscribe, send a message to [log in to unmask] with
following text in the body:
>To subscribe:   SUBSCRIBE TechNet <your full name>
>To unsubscribe:   SIGNOFF TechNet
>################################################################
>Please visit IPC web site (http://jefry.ipc.org/forum.htm) for additional
information.
>For the technical support contact Dmitriy Sklyar at [log in to unmask] or
847-509-9700 ext.311
>################################################################
>



Peter Mariani

mailto:[log in to unmask]

Phone 215.513.0850
Fax   215.513.0855

Visit http://www.electrostatics.com
to learn more about static electricity
and how to reduce its effects.

################################################################
TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe:   SUBSCRIBE TechNet <your full name>
To unsubscribe:   SIGNOFF TechNet 
################################################################
Please visit IPC web site (http://jefry.ipc.org/forum.htm) for additional information.
For the technical support contact Dmitriy Sklyar at [log in to unmask] or 847-509-9700 ext.311
################################################################