Dear Fellow TechNetters:
Is the current trend to model component land patterns from the center
of the part or from pin/pad 1? Whichever is the answer, what is the
justification for doing it that way? We are embarking on a project to
automate conversion of PADS board layout to a 3-D Unigraphics assembly
model and the aforementioned issue is a critical one.
Thanks in advance for any help and advice.
Anthony Bundrant
Design Engineer
Bell Helicopter Textron
P.O. Box 482
Fort Worth, TX 76101
Phone: (817) 280-8903
E-mail: [log in to unmask]
################################################################
TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe: SUBSCRIBE TechNet <your full name>
To unsubscribe: SIGNOFF TechNet
################################################################
Please visit IPC web site (http://jefry.ipc.org/forum.htm) for additional information.
For the technical support contact Dmitriy Sklyar at [log in to unmask] or 847-509-9700 ext.311
################################################################