Hi All,
Here's the issue:
We specify in our fab spec that all holes are to be within .003" of
their corresponding pad center (true position of .006"). We are being
told by our fab house that this tolerance is unreasonably tight.
Any comments???
Thanks,
Rick
################################################################
TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe: SUBSCRIBE TechNet <your full name>
To unsubscribe: SIGNOFF TechNet
################################################################
Please visit IPC web site (http://jefry.ipc.org/forum.htm) for additional information.
For the technical support contact Dmitriy Sklyar at [log in to unmask] or 847-509-9700 ext.311
################################################################