Typically, this can be done at the paste screen print operation during
assembly. Exposed vias for test on the secondary side that are ' mask-plugged'
on the primary side can be filled with solder paste and reflowed. This
increases the probe area for improved contact. Consult with your assembler for
stencil opening diameter and paste volume etc.
Regards,
Joe Gibson
HADCO
################################################################
TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe: SUBSCRIBE TechNet <your full name>
To unsubscribe: SIGNOFF TechNet
################################################################
Please visit IPC web site (http://jefry.ipc.org/forum.htm) for additional information.
For the technical support contact Dmitriy Sklyar at [log in to unmask] or 847-509-9700 ext.311
################################################################