Hello all;
I would be interested in hearing any comments about etching down 1oz.
copper foil to 1/4 oz or 3/8 oz. It is our understanding that this requires a
specific equipment set to control the uniformity of the thickness across
the panel surface; it is also our understanding that chemical control is
very important (although I am not sure what types of chemistry may used
for this process, i.e. cupric, sulfuric/peroxide, etc.).
Any suggestions for equipment and chemistries would be appreciated.
Regards,
Fred Johnson
JMSPI
################################################################
TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe: SUBSCRIBE TechNet <your full name>
To unsubscribe: SIGNOFF TechNet
################################################################
Please visit IPC web site (http://jefry.ipc.org/forum.htm) for additional information.
For the technical support contact Dmitriy Sklyar at [log in to unmask] or 847-509-9700 ext.311
################################################################