Mime-Version: |
1.0 |
Content-Type: |
text/plain; charset=US-ASCII |
X-To: |
|
Date: |
Wed, 11 Feb 1998 08:58:23 -0600 |
Reply-To: |
|
Subject: |
|
From: |
|
Content-Transfer-Encoding: |
7bit |
Sender: |
|
Parts/Attachments: |
|
|
We do not use paste for reworking PBGA's. A good no clean paste
flux, proper pad preparation and appropriate "no clean" profile will
provide you excellent results. We have the capability to also use the
paste printing method, but our investigations have shown that the
paste flux method yield more consistent results than the solder paste
method. Specifically, the BGA joint size is more uniform and there
are fewer and smaller voids introduced into the joints with paste
flux. We have never experienced opens with either process.
Our have been confirmed with HP (Laminography), Fein Focus (Oblique
Transmission) and functional testing. We have been using this process
for 2 years with 100% yield.
Thanks,
Mark McAuley
Process Engineer
Hitachi
______________________________ Reply Separator _________________________________
Subject: [TN] BGA Rework
Author: Stephane Richard <[log in to unmask]> at Internet-HICAM-OK
Date: 2/11/98 9:29 AM
We currently use solder paste when we do rework on PBGA's.
I m interested in knowing if it is required. I heard that the paste was
not required for PBGA's, only for CBGA's. Is that true ? If so, do we
only have to put flux on the board to be rework before putting the new PBGA ?
Thank in advance.
------------------------------------------------
Stephane Richard
Ingenieur de procedes
Process Engineer
Matrox Electronic Systems Ltd
E-mail: [log in to unmask]
Telephone:(514)969-6000 ext.7585
Pagette : (514)201-0044
Fax: (514)685-3415
-------------------------------------------------
################################################################
TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text
in the body:
To subscribe: SUBSCRIBE TechNet <your full name>
To unsubscribe: SIGNOFF TechNet
################################################################
Please visit IPC web site (http://jefry.ipc.org/forum.htm) for additional
information.
For the technical support contact Dmitriy Sklyar at [log in to unmask] or
847-509-9700 ext.311
################################################################
################################################################
TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe: SUBSCRIBE TechNet <your full name>
To unsubscribe: SIGNOFF TechNet
################################################################
Please visit IPC web site (http://jefry.ipc.org/forum.htm) for additional information.
For the technical support contact Dmitriy Sklyar at [log in to unmask] or 847-509-9700 ext.311
################################################################
|
|
|