Can someone direct me to an acceptance spec for PWB's concerning the
gold finger connector. We have a situation where the fabricator must
have dropped one end of the PWB prior to completely finishing the
chamfering process that resulted in the chamfer encroaching too much
into the finger length.
> E.A. Speer
> Artwork Engineer
> email: [log in to unmask]
> Telephone: (770) 246-8684
> Fax: (770) 246-8765
>
> American Megatrends, Inc.
> 6145-F Northbelt Parkway
> Norcross, GA 30071
> Telephone: (770) 246-8600
>
>
> http://www.ami.com
>
>
################################################################
TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe: SUBSCRIBE TechNet <your full name>
To unsubscribe: SIGNOFF TechNet
################################################################
Please visit IPC web site (http://jefry.ipc.org/forum.htm) for additional information.
For the technical support contact Dmitriy Sklyar at [log in to unmask] or 847-509-9700 ext.311
################################################################