Hi everyone !
Our PCboards are 0.062" thick. Actually, our cut-out for break-away tabs
are 0.093" and we would like to lower it to 0.062"or even 0.031" (to help
sensors to see the board)
Is there a specific minimum. standard in the industry to avoid price
increase and also to stay in Fab standard tools ??
Thanks in advance for any input !
ALaberge
Matrox electronic Systems
Quality Eng.
################################################################
TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe: SUBSCRIBE TechNet <your full name>
To unsubscribe: SIGNOFF TechNet
################################################################
Please visit IPC web site (http://jefry.ipc.org/forum.htm) for additional information.
For the technical support contact Dmitriy Sklyar at [log in to unmask] or 847-509-9700 ext.311
################################################################