Mime-Version: |
1.0 |
Sender: |
|
X-To: |
|
Date: |
Fri, 13 Feb 1998 08:49:09 -0800 |
Reply-To: |
|
Subject: |
|
From: |
|
In-Reply-To: |
|
Content-Type: |
text/plain; charset="us-ascii" |
Parts/Attachments: |
|
|
Just another data point. We recently purchased a Cyberoptics LSMII for
this purpose. We looked at and demoed an array of microscope focus based
units and found them to be very subjective between operators. Once the
lines that the operator overlays on the laser stipe image were adjusted to
approx. the same width as the laser image, repeatability was much better
with the cyberoptics unit. Having 4 different operators align on the same
gauge block target 10 times apiece, the variation wasn't more than +/- a
couple tens of a mil.
At 11:06 AM 2/10/98 -0600, you wrote:
>Charles Barker@I-O INC
>02/10/98 11:06 AM
>
>Some years ago, there was a mechanical system on the market for measuring
>the height of paste deposited on a pad. The system consisted of a small
>granite block, a needle attached to a Mititoyo measuring device that was
>moved by a thumbscrew and a monocular 'scope set at about a 30 degree angle
>with a back light.
>
>The measurement was taken by moving the needle down until it contacted the
>top of the paste, zeroing out the Mititoyo, then driving the needle down
>until it touched the pad itself. The Mititoyo then read out the thickness
>of the paste.
>
>Does anyone know of such a simple system out there anymore?
>
>TIA
>
>Charlie B.
>
>################################################################
>TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
>################################################################
>To subscribe/unsubscribe, send a message to [log in to unmask] with
following text in the body:
>To subscribe: SUBSCRIBE TechNet <your full name>
>To unsubscribe: SIGNOFF TechNet
>################################################################
>Please visit IPC web site (http://jefry.ipc.org/forum.htm) for additional
information.
>For the technical support contact Dmitriy Sklyar at [log in to unmask] or
847-509-9700 ext.311
>################################################################
>
>
>
Bryan Woods
Manufacturing Engineer
Parker Hannifin | Phone: (707)584-2542
Compumotor Division | Toll free: (800) 358-9068, ext 2542
5500 Business Park Drive | FAX: (707)584-8015
Rohnert Park,CA 94928 | Email: [log in to unmask]
| Web site: http:\\www.compumotor.com
################################################################
TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe: SUBSCRIBE TechNet <your full name>
To unsubscribe: SIGNOFF TechNet
################################################################
Please visit IPC web site (http://jefry.ipc.org/forum.htm) for additional information.
For the technical support contact Dmitriy Sklyar at [log in to unmask] or 847-509-9700 ext.311
################################################################
|
|
|