Sender: |
|
Subject: |
|
From: |
|
Date: |
Thu, 26 Feb 1998 17:16:00 MST |
X-To: |
|
Comments: |
|
Reply-To: |
|
Parts/Attachments: |
|
|
KwickFit is pretty good - but make sure you consult your fabricator for
their
keepout/tooling requirements. More infor on KwickFit can be found at:
http://www.micromeg.com/
Best regards,
Brad
----------
From: owner-designercouncil
To: DesignerCouncil
Subject: Re: [DC] Panelization Calculator
Date: Thursday, February 26, 1998 3:34PM
The one I am most familiar with is called ProPanel, but there
is another one called Kwikfit. Unfortunately, I just started a new
job and can't find either of them. sorry, but I just wanted you to know
that they exist (if no one else answers, I'll send 'em to ya later, ok?)
Good luck, Jack
> -----Original Message-----
> From: Jon R. DeGenova [SMTP:[log in to unmask]]
> Sent: Thursday, February 26, 1998 2:33 PM
> To: [log in to unmask]
> Subject: [DC] Panelization Calculator
>
> Does anyone know of software which a PCB designer can use to
> construct panelization configurations for optimum board house
> material utilization?
>
> Thank you.
>
> ################################################################
> DesignerCouncil E-Mail Forum provided as a free service by IPC using
> LISTSERV 1.8c
> ################################################################
> To subscribe/unsubscribe, send a message to [log in to unmask] with
> following text in the body:
> To subscribe: SUBSCRIBE DesignerCouncil <your full name>
> To unsubscribe: SIGNOFF DesignerCouncil
> ################################################################
> Please visit IPC web site (http://jefry.ipc.org/forum.htm) for
> additional information.
> For the technical support contact Dmitriy Sklyar at [log in to unmask] or
> 847-509-9700 ext.311
> ################################################################
################################################################
DesignerCouncil E-Mail Forum provided as a free service by IPC using
LISTSERV
1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following
text in the body:
To subscribe: SUBSCRIBE DesignerCouncil <your full name>
To unsubscribe: SIGNOFF DesignerCouncil
################################################################
Please visit IPC web site (http://jefry.ipc.org/forum.htm) for additional
information.
For the technical support contact Dmitriy Sklyar at [log in to unmask] or
847-509-9700 ext.311
################################################################
################################################################
DesignerCouncil E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe: SUBSCRIBE DesignerCouncil <your full name>
To unsubscribe: SIGNOFF DesignerCouncil
################################################################
Please visit IPC web site (http://jefry.ipc.org/forum.htm) for additional information.
For the technical support contact Dmitriy Sklyar at [log in to unmask] or 847-509-9700 ext.311
################################################################
|
|
|