 
| Mime-Version: |
1.0 |
| Sender: |
|
| X-To: |
|
| Date: |
Wed, 11 Feb 1998 09:59:17 -0600 |
| Reply-To: |
|
| Subject: |
|
| From: |
|
| X-cc: |
|
| In-Reply-To: |
<c=US%a=_%p=Electromagnetic_%l=NT_EXLXE-980211151421Z-3372@
nt_exems.elmg.com> |
| Content-Type: |
text/plain; charset="us-ascii" |
| Parts/Attachments: |
|
|
Chris,
Have you rechecked the system properties to see if there are any conflicts
with the address, interrupt, or DMA?
I am biased toward extenal modems. I have been using a USR Courier
V-everything for about 2 years now. I have not had problems with this
modem. Last time I checked the test reports it still ranked up there.
However it is not inexpensive. But then neither is your time, when
fighting these problems.
Neil D...
At 10:14 AM 2/11/98 -0500, Taylor, Chris H. wrote:
>I am at my wits end with my U.S.Robotics 33.6 Internal WinModem. I
>continue to get a message when attempting to run diagnosis from the
>"System" Program Group that reads "Unable to open Port". Windows 95 will
>simply not recognize the modem. I have reloaded Windows 95 as well as
>Winmodem, to no avail. I have tried uninstalling and reinstalling
>Winmodem and even edited out the program from REGEDIT in the uninstall/
>reinstall effort. The frustrating part is that it USED TO WORK!! Has
>anyone had similar problems with their Winmodem? I also went through the
>suggestions given by USR tech support to no avail. Is this just a piece
>of garbage that I should simply count my losses on and replace? Any
>feedback shall be appreciated.
>
>
>Chris Taylor
>Senior Printed Circuit Designer
>LXE, Inc.
>125 Technology Parkway
>Norcross, GA 30092
>voice: (770) 447-4224 X3242
>fax: (770) 447-6928
>e-mail: [log in to unmask]
>
____________________
/ /\
/ Neil Diamond / \
/ [log in to unmask] / \
/___________________/------\
################################################################
DesignerCouncil E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe: SUBSCRIBE DesignerCouncil <your full name>
To unsubscribe: SIGNOFF DesignerCouncil
################################################################
Please visit IPC web site (http://jefry.ipc.org/forum.htm) for additional information.
For the technical support contact Dmitriy Sklyar at [log in to unmask] or 847-509-9700 ext.311
################################################################
|
|
|
